In normal operation, any washing machine can fill and flush at least twice per wash: before the wash and directly during the rinse.
The total number of cycles is determined by the automatic washing machine set time.
Determining fault is easy, just enough to understand that the machine begins to fill water too often, this will be the main sign of the problem.
The washing machine constantly fills and drains water
Such immeasurable "greed" of the washing machine in relation to the water intake indicates improper installation or some breakdown inside.
In any case, each problem should always be solved. In a bad case, you will burden yourself with constant washing, because of the inefficiency of the machine, with a huge waste of water, or in general your device can "break", even flooding the neighbors.
Filled with water
If you have recently installed a washing machine, this may indicate that when connecting the machine to the sewer there were some problems, and the installation went wrong.
Perhaps the water itself goes from the tank to the sewer, because the hose is installed below the loading tank. In this case, the appliance will say that there is not enough water and constantly draw new water.
How to check the correct connection of the washing machine?
In the case of a normal connection of the machine, the drain hose is located above the tank: it is attached either to a siphon or to a sewer pipe, rising 50-60 cm above the floor.
Therefore, if you feel that the not so long ago connected appliance takes on too much water - be sure to check the level of the drain.
Although, there is still the possibility of inability to see the place of connection due to other objects in the house. Then do this check: turn on the machine and wait for the tank to fill with water.
Then turn on the "drain" and while the water is flowing out, pause it. And watch the remaining water: if when you press pause, the drain has stopped - everything is fine. But if the water is still flowing out (you will notice it and probably hear it) - it means that there is still a problem in the connection. In this case, it is better to postpone the washing process and call a master, who will reinstall your washing machine.
But if the machine appeared to you long ago, and all this time worked correctly, but suddenly began to ask for water in huge quantities, then the matter here is an "internal" problem. Something is faulty. Then you need to unplug the appliance, shut off the water supply hose and drain the water with an extra filter.
If the problem with the water drain could not be solved, leave a request to the master, we will help you!
Thank you so much for such a detailed schematic explanation!