Leave a request and we'll solve your problem:
The water level in your washing machine is out of order?
When choosing a washing machine today, many people pay special attention to the washing class, i.e. the efficiency and economy of the appliance. In the priority washing machines, which consume less resources, such as water and electricity.
One of the main resources consumed by a washing machine is water, as all the cycles of the machine are aimed at using this resource.
Water Level Sensor
Water level in the washing machine - is one of the main parameters, the calculation of which allows the machine to start the washing cycle without interference. The amount of water coming in for washing is controlled by the level switch. This is a sensor which is active during the whole washing cycle, as it monitors the water level in the washing machine throughout the washing and rinsing.
Too much water is coming in
If you see that the water level in the washing machine is higher than normal, it indicates ., which include: broken water inlet valve, broken presostat (level sensor), improper installation of the machine and low attachment of the drain hose, etc.
Troubleshooting
- Incorrect installation. First of all, check that the machine is correctly installed and connected. The required height of attachment of the drain hose is specified in the manual. If the drain fixed too low - the water level in the washing machine will be lower than normal, because water will simply flow out of the tank into the sewer, and the machine will constantly draw water.
- The drain valve has failed. A faulty drain valve is indicated by the fact that the water flows into the machine when it is turned off and even with the door open. In this case, the water flows into the tank, because the valve can not withstand the pressure available in the water pipes.
Sometimes this happens because the valve is broken, sometimes - because of a simple clog. Replacing the valve is not a complicated procedure, A technician will replace the part in a matter of minutes. Before the arrival of the master it is important to turn off the tap on the pipe to which the washing machine is connected. Otherwise, the water will gradually fill the tank and begin to flood the room.
Weak water pressure. If the water pressure in the system is low, the water level in the washing machine rises too slowly. In this case, the electronic module can give an error. The problem with no water or low water pressure is solved by the building manager and maintenance company. However, before you call the utility company, check that the water in the apartment is not blocked or the valve on the pipe is not turned.
- Defective level sensor. If the water continues to fill the tank of the washing machine, although the water level in the washing machine is already high enough, then the level switch is broken. Check the sensor for serviceability and replace it if necessary can Repairman can check the sensor and replace it if necessary.
Keep an eye on the water level in your washing machine - it will help you notice the problem and fix it in time.
Leave a repair request:
