Leave a request for washing machine repair:

One of the troubles that can happen to your washing machine is a leak. When water leaks from the washing machine - it is a cause for concern, because even the smallest leak can cause flooding of your apartment and the apartment of the neighbors

Causes of leakage

First of all, you should make sure that the cause of the appearance of water in the malfunction of the machine. It is possible that the pipe, riser, or faucet tube is leaking. If there are no visible leaks in the water and sewer systems, then the washing machine is the cause.

 

Water leaks from the washing machine most often for the following reasons:

• the pump leaks;
• the tank is leaky;
• one of the hoses is damaged (drain or fill);
• the door cuff is damaged;
• Leaky pipes;
• The tank packing is damaged;
• Dispenser is clogged, etc.

Fixing the situation

Carefully examine the machine and determine the location of the leak. It is also important to know at what point in the washing process water leaks from the washing machine. The answer to this question will determine the final "diagnosis", because different systems of the machine can be worn out and damaged: the drain system, water intake system, etc. If water is dripping slowly throughout the wash and rinse cycle, it may be leaking through a damaged tank lid collar.

Hoses leaking

Most often, the hoses leak at the joints. This trouble is fixed quite simply - you need to replace the rubber gasket. The damaged hose should be replaced with a new leak-proof one, since the use of glue is most often not effective.

• Faulty pipette

The main cause of a leaky dispenser is a clogged powder hopper, as well as too much water pressure during washing. Sometimes leaks are also due to problems with the inlet valve.

Remove the dispenser and, if clogged, rinse in running water. Inspect the area where the spout is inserted for foreign objects, and if found, remove them.

If you find a leak on the inlet valve, it will most likely have to be replaced.

Damaged protective sleeve

Minor damage to the rubber cuff can be repaired with a patch and water-resistant adhesive. If the damage is extensive, the cuff must be replaced. A cuff that has dried out and cracked should also be replaced.

Tubes are leaking

If the water leaks from the washing machine due to the loosening of the socket with the tank, it is necessary to remove the socket, clean and dry the place of attachment, and then reattach the part. To ensure that the problem does not arise again, it is important to use high quality waterproof adhesive.

Damaged spigots will have to be replaced. In this, you will help a washing machine repairman.

There is damage to the tank

To find damage to the tank at the machine with front-loading inspect the bottom, the machines with vertical loads to inspect it is necessary to remove the side of the body. Damaged tank must be replaced. To do this, contact a specialist.

• Faulty oil seal

A malfunction of this part is indicated by water leaking from the washing machine during spinning. To diagnose this problem can be diagnosed by inspecting the tank and noticing water leaking from the bearings. Faulty packing and bearings should also be replaced.

• The pump is leaking

If water leaks from the washing machine due to a fault in the drain pump (pump), it should also be replaced.

Problems with leaks in the washing technique is not so rare, it is important to notice the problem in time and make a quality repair.

To leave a request to call a master: