The following may happen with washing machine Samsung: some time after the beginning of washing you find that you do not hear the set of water in the tank and you pay attention that on the electronic display is lit one of the error code 1C, 1E, and on models manufactured before 2007, E7. The error may have appeared during the previous wash, at the time of the spin or rinse, but you did not pay attention to it at that moment. But after 10-20 seconds of a new cycle it happened again and stopped the machine.
If there is no display on the control panel, you can determine this error by the hot water wash indicator light and the 60, 40 degree temperature indicators, while the other indicators are blinking.
Error explanation
In the device of the Samsung household appliance, there is such a part as the pressostat. In other words, it is a sensor controlling the water level. When the sensor fails, it produces a frequency that does not correspond to the washing cycle, the water is drained and error 1E, 1C, E7 appears on the display. Most often it means a pressostat failure, but at first it is recommended to try to solve the problem yourself.
Your actions when error code 1E appears on the monitor of your Samsung washing machine:
It is quite possible that you will be able to fix this breakdown without calling a master. To do this, do the following:
- Check the control module.
Disconnect the appliance from the mains and switch it on after no earlier than 5 minutes. Restarting the controller with a high probability will restore the washing machine performance.
- Check the contacts of pressostat and control board.
Probably one of the connectors on the control board or pressostat is loose. It is necessary to look through all the contacts and correct them if possible.
- Check the pressostat tube.
You need to see if the sensor tube that connects it to the pressure chamber is disconnected, or if there is a kink in it. It serves to ensure that at the time of filling the tank triggered pressure extraction and the water stopped flowing. In case of a kink or disconnection, error 1E (E7,1C) is sure to be displayed. This can be easily corrected by yourself.
Call a professional
The table below lists faults that can be fixed when this error occurs by a technician By repairing or replacing parts, as well as the cost of these works:
| Signs Error symptom |
Possible cause of the error | Necessary actions
|
Cost of repair, including spare parts, rub. |
| No water in machine tank; the code 1E, 1C or E7 appears on the display. The first error signal can occur at any time of washing | The most common breakdown is pressostat failure for one of the reasons:
|
Replace the pressostat or repair the pressure sensor hose in one of the following ways:
|
1500-3800 |
| Monitor shows error 1E,1C when starting the machine | Control module failure due to problems with the processor in the chip. Possibly burned out resistors and no contact between control board and pressostat. | Resoldering resistors at the control module
Or replacement of the control module in case of processor failure |
3900-5600 repair
7100 replacement |
| In the first minute the display gives out code E7,1E. Machine without display had error message with combination of indicators (see above) | Wiring from pressostat to control module does not work, possibly damaged or oxidized contacts. | Cleaning of contacts at water level sensor, replacement of internal wires in case of ineffective stranding | 1600-3000 |
**All repairs are usually covered under warranty for up to two years.
You can leave an online request to the technician 24 hours a day. In it you can briefly describe your problem, be sure to specify the model of your washing machine, and leave contacts for feedback.
A specialist will arrive at your chosen time from 9.00 to 21.00, will diagnose your appliance, calculate the cost of repair given your model of washing machine Samsung and will make all the necessary work to eliminate the error 1E(1C,E7). If you are not satisfied with the price, you can refuse to repair, in this case, you do not have to pay for repairs specialist, only 400-5$ for the diagnosis of the problem
